Dell Brocade DCX, Configuration Manual

Page: 817 / 1436

BigIron RX Series Configuration Guide 745
53-1001810-01
Configuring BGP4
26
The address family command also requires you to select a sub-address family, which is the type of
routes for the configuration. You specify multicast or unicast routes.
FIGURE 112 BGP configuration levels
Table 26.1 shows what commands are available at the various BGP configuration levels.
TABLE 116 IPv4 BGP commands at different configuration levels
Command Global
(iPv4 and
IPv6) IPv4 address
family unicast IPv4 address
family
multicast See
address-family x x x “Entering and exiting the address family
configuration level”
on page 749
address-filter x “Filtering specific IP addresses” on page 749
aggregate-address x x “Aggregating routes advertised to BGP4
neighbors”
on page 757
always-compare-med x “Configuring the BigIron RX to always
compare Multi-Exit Discriminators (MEDs)”
on
page 757
as-path-filter x
as-path-ignore x “Disabling or re-enabling comparison of the
AS-path length”
on page 758
bgp-redistribute-internal x “Redistributing IBGP routes” on page 758
client-to-client-reflection “Disabling or re-enabling client-to-client route
reflection”
on page 759
cluster-id x “Configuring a route reflector” on page 759
community-filter x
compare-routerid x “Enabling or disabling comparison of the
router IDs”
on page 759
confederation x “Configuring confederations” on page 760
dampening x x “Configuring route flap dampening” on
page 763
default-information-origi
nate x x “Originating the default route” on page 764
router bgp
Global commands for BGP
and all address families
address-family
IPv4
address-family
IPv6 unicast
Commands for IPv6
BGP unicast routes
unicast
Commands for IPv4
MBGP routes
multicast
Commands for IPv4
BGP unicast routes