Creo Color Controller C-80, Technical Manual

Page: 93 / 150

77
4.4.12 Disk Striping
Perform disk striping if the
Wrong Disk Configuration
message appears. This
message may appear in the following instances:
•
The operating system does not identify a disk because a cable, such as a
SATA2 or power cable, is faulty or not connected properly. See
Troubleshooting
on page 67.
•
The operating system and the Color Controller C-80 software have been
installed from scratch, and the operating system only recognizes foreign disks.
See
Striping Foreign Disks on page 78.
•
An image disk either has been replaced with a new disk, and the operating
system identifies it as an unknown disk. See
Striping Unknown Disks on
page 80.
•
A faulty image disk has been replaced with a new disk, and the new disk is
intermittenly unavailable. See
Removing a Missing Disk on page 82.
To establish the correct disk striping procedure:
1. If the following message appears, click OK.
The Computer Management window appears.
Note: If the
Image Disks File System is not Formatted
message
appears, proceed to step 2 of the Confirming the Disk Striping procedure on
page 85.