Creo Color Controller C-80, Technical Manual

Page: 117 / 150

101
5.5.3 Replacing System Board Memory Modules
The Color Controller C-80 comes with Dual In-line Memory Modules (DIMMs) that
are installed on the system board in DIMM bank #1A (blue) and DIMM bank #1B
(blue).
Figure 15: DIMM module locations
Preparing to Remove a DIMM
1. Review Safety Information (Multi-Language) on page v.
2. Turn off the Color Controller C-80 and all peripheral devices. Disconnect all
external cables and power cords.
3. Remove the side cover. See Removing the Side Cover on page 94.
4. Verify which DIMM you want to remove. See Figure 16 on page 102.
Removing a DIMM
1. Press down on the two DIMM release tabs so that they rotate outward, releasing
the memory from its seat.
2. Gently pull the DIMM up and out of the server.
Note: Removing or installing DIMMs may change the configuration information in
the server. Therefore, after removing or installing a DIMM, save the new
configuration information by using the BIOS setup utility program. When you
restart the server, the system displays a message indicating that the memory
configuration has changed.
Attention: When you handle electrostatic discharge (ESD) sensitive devices,
take precautions to avoid damage from static electricity.
Attention:
To avoid breaking the release tabs or damaging the DIMM
connectors, handle the clips gently.