Creo Color Controller C-80, Technical Manual

Page: 112 / 150

96 Chapter 5—Hardware and Maintenance Repairs
5.4.3 Removing the Front Panel
1. Review System Reliability Considerations on page 93.
2. Turn off the Color Controller C-80 and all peripheral devices. Disconnect all
external cables and power cords.
3. Remove the side cover (see Removing the Side Cover on page 94).
4. Inside the chassis, lift the two protruding tabs that secure the front panel to the
front of the chassis and move the edge of the front panel slightly away from the
chassis. See step 4 in Figure 10 and Figure 11 on page 97.
5. Using a flat screwdriver, gently pry the four concealed tabs along the edge of
the front panel away from the chassis.
Figure 10: Removing the front panel
Tip:
It is easier to perform this procedure if you place the server on its side on
a table, with the front panel of the tower computer case protruding over the
table edge.
4 Inside the chassis, lift the two protruding tabs.
5 Pry the edge of the front panel away from the chassis and open
outward.
5
4