Creo Color Controller C-80, Technical Manual

Page: 82 / 150

66 Chapter 4—Diagnostics and Troubleshooting
4.3.4 Board Diagnostics
This section describes the diagnostics for the Color Controller C-80 boards.
The board included in this category is FusionRA.
Use the JOIND diagnostic utility to test the Color Controller C-80 boards. If a board
fails a test, first verify that it is properly connected (turn off the Color Controller C-80
and check the board connections including cables and pins; sometimes boards may
become loose in the PCI slot).
FusionRA Board
Testing Input/Output Memory Modules
Tests the input and output memories on the FusionRA board.
Testing the Fusion
RA
Board
Tests the internal electrical mechanism of the FusionRA board.
4.3.5 Performing a Diagnostic Test
1. Access the JOIND software. See Activating the Diagnostics Software on
page 61.
2. Select the components for testing from the diagnostics tree, or select DFE to
test the entire tree, or select Load Quick Batch from the File Menu. See File
Menu on page 63.
3. Click the Loop button to run the tests in loop mode.
4. Click the Run button to activate the diagnostics testing.
5. The system performs the tests and the results appear in the area of the
diagnostics tree: Pass or Fail.
6. If there are components that fail, click the Errors button to view all failed
components or click the Quick Error button to view a specific selected test.
Diagnostics Test Results
Important:
Replace a board or a system component that continues to fail
its diagnostics test.
Note: Exit the Color Controller C-80 software prior to running the diagnostics
program.
Important:
Prior to activating the diagnostics software, verify that the
drivers were loaded successfully (with no error messages during driver
loading).