Creo Color Controller C-80, Technical Manual

Page: 24 / 150

8 Chapter 2—First Time Setup and Configuration
2.1 Connecting the Color Controller C-80
Connect the
Color Controller C-80
to your printer as illustrated in Figure 2, below.
Figure 2: Connecting the Color Controller C-80
2.1.1 Connecting the Color Controller C-80 to the Printer
To enable communication between the printer and the Color Controller C-80, you
need to enter the SP mode on the printer, and then select the correct SP5193-001
settings.
1. On the printer display panel, press Clear Modes .
2. Type 107, and press C (Clear) until the SP mode appears.
3. Touch System Sp .
4. Use the buttons on the touch screen to navigate to the SP5193-001 setting
(External Controller Info. Settings).
5. Type 5 , and then press the # ( Enter) key.
6. Touch Exit when the message to reboot the printer appears.
Note: During the process of connecting the
Color Controller C-80 to the printer, you will
need to turn the printer off and then turn it back on.
7. Turn off the printer using the main power switch that is located behind the front
cover.
For more information, see the Easy Setup Steps chart supplied with your
Color Controller C-80.