![background image](http://html1.mh-extra.com/html/carrier/vector-1800-mt/vector-1800-mt_operation-and-service-manual_2564194192.webp)
62-11039
7-61
Alarm
NO.
Steps
ALARM / CAUSE
CORRECTIVE ACTION
129 CHECK ENG COOLANT SENSOR
•
TRIGGER–ON: Engine Coolant Sensor is not within the range of --58
°
F to +266
°
F
(--50
°
C to +130
°
C)
(
)
•
UNIT CONTROL: Engine and standby operation: alarm only.
•
RESET CONDITION: Auto Reset or alarm may be manually reset via keypad or by turning the unit off,
then back on again.
NOTE: Follow the steps below until a problem is found. Once a repair or correction has been made, the active alarm
should clear itself (see reset condition above). Operate the unit through the appropriate modes to see if any active
alarm occurs. Continue with the steps below as necessary.
1.
Check Engine Coolant Sensor
a. Inspect Engine Coolant Sensor &
connector
No damage to sensor
No damage, moisture, or corrosion in connector
b. Check Engine Coolant Sensor
resistance (See Note 4)
(Refer to Table 8-8 for complete resistance chart)
10,000 Ohms @ 77
°
F (25
°
C)
2.
Check Engine Coolant Sensor Wiring
a. Inspect harness & control box
connector pins & terminals (See
wiring schematic)
No physical damage to harness.
No damaged or corroded pins
Summary of Contents for VECTOR 1800 MT
