Carrier VECTOR 1800 MT, Operation & Service Manual

Page: 69 / 315

62-11039 3-19
Table 3-1. UNIT DATA
* Also appear in Configurations
+ May or may not be displayed depending on functional parameter settings
DATA DEFINITION
SUCTION PRESSURE Compressor suction pressure
DISCHARGE PRESSURE Compressor discharge pressure
EVAPORATOR PRESSURE Suction pressure in the evaporator section
ENGINE COOLANT TEMP
Engine coolant temperature
RETURN AIR TEMP Compartment 1 return (air entering evaporator) air temperature
C2 RETURN AIR TEMP Compartment 2 return (air entering evaporator) air temperature
C3 RETURN AIR TEMP Compartment 3 return (air entering evaporator) air temperature
SUPPLY AIR TEMP Compartment 1 supply (air leaving evaporator) air temperature
C2 SUPPLY AIR TEMP Compartment 2 supply (air leaving evaporator) air temperature
DELTA--T Return air temperature minus Supply air temperature in compartment 1
only
AMBIENT AIR TEMP Ambient (air entering condenser) air temperature
DEFROST TERM TEMP 1 Compartment 1 defrost termination temperature
C2 DEFROST TERM TEMP Compartment 2 defrost termination temperature
C3 DEFROST TERM TEMP Compartment 3 defrost termination temperature
SUCTION LINE TEMP
Suction line temperature at the compressor
EVAP OUTLET TEMP Suction line temperature at the evaporator outlet
DISCHARGE TEMP Compressor discharge temperature
BATTERY Battery voltage
CURRENT DRAW Battery charging or discharging amps.
ENGINE RPM Engine revolutions per minute
UNIT AC CURRENT #1 High voltage current draw on circuit #1.
UNIT AC CURRENT #2 High voltage current draw on circuit #2.
FUEL LEVEL % of fuel in tank. (This is only shown when 0% -- 100% sensor is config-
ured ON.)
SUCTION MOD VALVE
% open of CSMV
EXPANSION VALVE
% open of EVXV
START MODE AUTO if the engine will start automatically
MANUAL if the engine must be started manually
INSTALLED OPTIONS
INTELLISET INSTALLED
Applies only if unit has these installed options.
SOFTWARE REVISION Revision of the software that is operating the microprocessor
DISPLAY SOFTWARE REV Revision of the software that is operating the display
CONTROL SERIAL #
Serial Number of the microprocessor
*
TRAILER ID # ID (as entered by the user)
*
UNIT SERIAL # Unit serial number