![background image](http://html1.mh-extra.com/html/carrier/vector-1800-mt/vector-1800-mt_operation-and-service-manual_2564194147.webp)
7-16
62-11039
Alarm
NO.
Steps
ALARM / CAUSE
CORRECTIVE ACTION
23
A/C CURRENT OVER LIMIT (Continued)
•
UNIT CONTROL: Engine operation: this alarm will not activate in engine operation. Standby operation:
refrigeration system shutdown and alarm with PSCON still energized.
•
RESET CONDITION: Auto reset after 15 minutes or alarm may be manually reset via keypad or by
turning the unit OFF, then back ON.
NOTE: Follow the steps below until a problem is found. Once a repair or correction has been made, the active alarm
should clear itself (see reset condition above). Operate the unit through the appropriate modes to see if any active
alarm occurs. Continue with the steps below as necessary.
1.
Check For Electrical Failure In System
a. Check electrical motors
Run pre--trip; Determine motor or refrigeration component
failure per pre--trip Alarm. Ohm test component per
Section 2.13
Listen for noise caused by failed bearing or motor
obstruction
b. Defective wiring
Check for discolored wiring at contactors and loose
connections
c. Defective contactor
Remove and replace suspected contactor
2.
Defective Overload Protector
a. Wrong setting
Readjust setting to 30 amps
3.
Defective Current Sensor
a. Reads too high
Remove and replace
4.
Check Generator Voltage (If Used When Alarm Occurred)
a. Check voltage at GENCON L1--L2,
L1--L3, L2--L3
Should be 440 to 580 VAC
5.
Check Power Source Voltage (If Used When Alarm Occurred)
a. Check voltage at PSCON L1--L2,
L1--L3, L2--L3
Should be 440 to 580 VAC
6.
Check Voltage Output From Contactors
a. Check voltage at GENCON T1--T2,
T1--T3, T2--T3
Should be 440 to 580 VAC
b. Check voltage at CCON with
compressor operating. T1--T2,
T1--T3, T2--T3
Should be 440 to 580 VAC
7.
Verify AC Current Sensor Accuracy
a. Turn all compartment switches OFF,
and RS ON.
Unit AC Current #1 and #2 reading in Data List must be
0.0
1.0 amp.
Summary of Contents for VECTOR 1800 MT
