![background image](http://html1.mh-extra.com/html/carrier/vector-1800-mt/vector-1800-mt_operation-and-service-manual_2564194263.webp)
8-10
62-11039
8.6.8 Servicing Glow Plugs
The total circuit amp draw for the glow plug circuit is
checked during a Pretrip cycle. When servicing, the
glow plug is to be fitted carefully into the cylinder head to
prevent damage to glow plug. Torque value for the glow
plug is 14 to 18 ft-lb (1.9 to 2.5 Mkg).
Checking for a Defective Glow Plug
a. The entire circuit may be tested using Component
Test Mode. (Refer to Section 5.2.2.)
b. To test individual glow plugs, disconnect all glow
plugs from each other, and place an ammeter (or clip-
on ammeter) in series with each glow plug and ener-
gize the plugs. See Table 2-5 for glow plug amperage.
8.6.9 Water Pump V--Belt
The water pump v-belt is driven by a sheave on the
engine crankshaft. Frayed, cracked or worn belts must
be replaced. This belt is a one time use only type and
require no tension adjustment.
Water Pump Belt
Figure 8--9. Water Pump V--Belt
Summary of Contents for VECTOR 1800 MT
