Bull Escala BL460, Problem Determination And Service Manual, Page: 80 / 266

60
Escala BL460 - Problem Determination and Service Guide
• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
•
See Chapter 3 , “ Parts listing ,” on page 197 to determine which components are CRUs and which
components are FRUs.
Error code Description Action
BA131010 The USB keyboard has been removed.
1. Reseat the keyboard cable in the management module
USB port.
2. Check for server firmware updates; then, install the
updates if available.
BA140001
The SCSD read/write optical test unit
ready failed; hardware error.
1. Troubleshoot the SCSD devices.
2. Verify that the SCSD cables and devices are properly
plugged. Correct any problems that are found.
3. Replace the SCSD cables and devices.
4. If the problem persists:
a. Go to “ Checkout procedure ” on page 148 .
b. Replace the system-board and chassis assembly, as
described in “ Replacing the Tier 2 system-board and
chassis assembly ” on page 229 .
BA140002
The SCSD read/write optical test unit
ready failed; sense data available.
1. Troubleshoot the SCSD devices.
2. Verify that the SCSD cables and devices are properly
plugged. Correct any problems that are found.
3. Replace the SCSD cables and devices.
4. If the problem persists:
a. Go to “ Checkout procedure ” on page 148 .
b. Replace the system-board and chassis assembly, as
described in “ Replacing the Tier 2 system-board and
chassis assembly ” on page 229 .
BA140003
The SCSD read/write optical send
diagnostic failed; sense data available.
1. Troubleshoot the SCSD devices.
2. Verify that the SCSD cables and devices are properly
plugged. Correct any problems that are found.
3. Replace the SCSD cables and devices.
4. If the problem persists:
a. Go to “ Checkout procedure ” on page 148 .
b. Replace the system-board and chassis assembly, as
described in “ Replacing the Tier 2 system-board and
chassis assembly ” on page 229 .
BA140004
The SCSD read/write optical send
diagnostic failed; devofl command.
1. Troubleshoot the SCSD devices.
2. Verify that the SCSD cables and devices are properly
plugged. Correct any problems that are found.
3. Replace the SCSD cables and devices.
4. If the problem persists:
a. Go to “ Checkout procedure ” on page 148 .
b. Replace the system-board and chassis assembly, as
described in “ Replacing the Tier 2 system-board and
chassis assembly ” on page 229 .
BA150001
PCI Ethernet BNC/RJ-45 or PCI Ethernet
AUI/RJ-45 adapter: internal wrap test
failure
Replace the adapter specified by the location code.
BA151001
10/100 Mbps Ethernet PCI adapter:
internal wrap test failure
Replace the adapter specified by the location code.
BA151002 10/100 Mbps Ethernet card failure
1. Go to “ Checkout procedure ” on page 148 .
2. Replace the system-board and chassis assembly, as
described in “ Replacing the Tier 2 system-board and
chassis assembly ” on page 229 .
BA153002 Gigabit Ethernet adapter failure
Verify that the MAC address programmed in the
FLASH/EEPROM is correct.