Bull Escala BL460, Problem Determination And Service Manual, Page: 232 / 266

212
Escala BL460 - Problem Determination and Service Guide
4.4.6 Installing a drive
You can install a hard disk drive or a solid state drive (SSD).
Figure 4-8 shows how to install the SAS drive.
Figure 4-8.
Installing a SAS hard disk
To install a drive, complete the following steps:
1. Read “ Safety ” on page vii and the “ Installation guidelines ” on page 201 .
2. Shut down the operating system, turn off the blade server, and remove the lade server
from the Bull Blade Chassis - Enterprise. See “ Removing the blade server from a Bull
Blade Chassis - Enterprise ” on page 203 .
3. Carefully lay the blade server on a flat, static-protective surface, with the cover side
up.
4. Open and remove the blade server cover. See “ Removing the blade server cover ”, on
page 206.
5. Locate the connector for the drive.
6. Place the drive 1 into the hard disk drive tray and push it toward the rear of the
blade, into the connector until the drive moves past the lever at the front of the tray.
Attention: Do not press on the top of the drive. Pressing the top might damage the
drive.