Bull Escala BL460, Problem Determination And Service Manual, Page: 171 / 266

Chapter 2. Diagnostics
151
Step 007
Perform the following steps:
1. Use the management-module Web interface to make sure that the device from which
you load the stand-alone diagnostics is set as the first device in the blade server boot
sequence.
2. Turn off the blade server and wait 45 seconds before proceeding.
3. Turn on the blade server and establish a SOL session.
4. Check for the following responses:
a.
Progress codes are recorded in the management-module event log.
b. Record any messages or diagnostic information that might be in the log.
Continue with step 008.
Step 008
Load the stand-alone diagnostics. Go to “ Starting stand-alone diagnostics from a CD ” on
page 152 or “ Starting stand-alone diagnostics from a NIM server ” on page 153 .
Can you load the stand-alone diagnostics?
No Go to “ Solving undetermined problems ” on page 194 .
Yes Select the resources to be tested and record any SRNs; then go to “ Service
request numbers (SRNs) ” on page 109 .
This ends the Linux procedure.