Bull Escala BL460, Problem Determination And Service Manual, Page: 245 / 266

Chapter 4. Removing and replacing blade server components
225
6. Use your finger to press down on one side of the battery; then, slide the battery out
from its socket. The spring mechanism will push the battery out toward you as you
slide it from the socket.
Note You might need to lift the battery clip slightly with your fingernail to make it easier to slide
the battery.
7. Use your thumb and index finger to pull the battery from under the battery clip.
Note After you remove the battery, press gently on the clip to make sure that the battery clip is
touching the base of the battery socket.
4.4.13 Installing the battery
You can install the battery.
Figure 4-18.
Installing the battery
The following notes describe information that you must consider when replacing the battery
in the blade server.
• When replacing the battery, you must replace it with a lithium battery of the same type
from the same manufacturer.
•
After you replace the battery:
a.
Set the time and date.
b. Set the Network IP addresses (for blade servers that start up from a network).
c. Reconfigure any other blade server settings.