Bull Escala BL460, Problem Determination And Service Manual, Page: 224 / 266

204
Escala BL460 - Problem Determination and Service Guide
3. Press the power-control button (behind the control-panel door) to turn off the blade
server. See “ Turning off the blade server” on page 11 .
4. Wait at least 30 seconds for the hard disk drive to stop spinning.
5. Open the two release handles as shown in the illustration. The blade server moves out
of the bay approximately 0.6 cm (0.25 inch).
6. Pull the blade server out of the bay. Spring-loaded doors farther back in the bay move
into place to cover the bay temporarily.
7. Carefully lay the blade server on a flat, static-protective surface, with the cover side
up.
8. Place either a blade filler or another blade server in the bay within 1 minute.
The recessed spring-loaded doors move out of the way as you insert the blade server
or filler blade.
4.3 Installing the blade server in a Bull Blade Chassis - Enterprise
Install the blade server in a Bull Blade Chassis - Enterprise to use the blade server.
Figure 4-2. Installing the blade server in a Bull Blade Chassis - Enterprise
Perform the following procedure to install a blade server in a Bull Blade Chassis -
Enterprise.
1. Download the firmware so that you can use it later to update the blade server after
you start it.
2. Read “ Safety ” on page vii and the “ Installation guidelines ” on page 201 .