AudioCodes Mediapack mp-11x, User Manual

Page: 52 / 390

SIP User's Manual 52 Document #: LTRT-65409
MediaPack Series
c.
Save these settings to the flash memory and reset the gateway by performing the
following:
a.
Click the
Maintenance
button on the main menu bar; the 'Maintenance
Actions' screen is displayed.
b.
From the 'Burn to FLASH' drop-down list, select 'Yes', and then click the
Reset
button; the gateway shuts down and restarts.
2.
Use a standard Telnet application to connect to the gateway's embedded Telnet
server. Note that if the Telnet server is set to SSL mode, a special Telnet client is
required on your PC to connect to the Telnet interface over a secured connection.
3.
Login using the default username (‘Admin’) and password (‘Admin’).
The procedure below describes how to establish a serial communications link with the
gateway (using serial communication software such as HyperTerminal
TM
) through the RS-
232 interface.
¾
To access the CLI using the RS-232 port , take these 2 steps:
1.
Connect the gateway's RS-232 port to your PC (for MP-11x refer to Connecting the
MP-11x RS-232 Port to Your PC on page
34 ; for MP-124, refer to Connecting the MP-
124 RS-232 Port to Your PC on page 43 ).
2.
Use a serial communication software (e.g., HyperTerminal
TM
) with the following
communications port settings:
•
Baud Rate: 115,200 bps (MP-124); 9,600 bps (MP-11x)
•
Data bits: 8
•
Parity: None
•
Stop bits: 1
•
Flow control: None
The CLI prompt appears.
4.3.4.2 Assigning an IP Address
Once you have accessed the CLI, follow the procedure below for assigning a new IP
address.
¾
To assign an IP address via the CLI, take these 4 steps:
1.
At the prompt, type
conf
, and then press <Enter>; the configuration folder is
accessed.
2.
To view the current network parameters, at the prompt, type
GCP IP
, and then press
<Enter>; the current network settings are displayed.
3.
Change the network settings by typing the following:
SCP IP [ip_address] [subnet_mask] [default_gateway]
For example,
SCP IP 10.13.77.7 255.255.0.0 10.13.0.1
The new settings take effect on-the-fly. Connectivity is active at the new IP address.
Note:
This command requires you to enter all three network parameters (each
separated by a space).
4.
To save the configuration, at the prompt, type
SAR
, and then press <Enter>; the
gateway restarts with the new network settings.