AudioCodes Mediapack mp-11x, User Manual

Page: 102 / 390

SIP User's Manual 102 Document #: LTRT-65409
MediaPack Series
Table 5-12: General Parameters (Advanced Parameters)
Parameter Description
Enable Digit Delivery to Tel
[EnableDigitDelivery]
ƒ
[0]
Disable = Disabled (default).
ƒ
[1]
Enable = Enable Digit Delivery feature for the FXO/FXS gateway
The digit delivery feature enables sending DTMF digits to the gateway's
port after the call is answered [line offhooked (FXS) or seized (FXO)].
For IP-to-Tel calls, after answering the call, the gateway plays the DTMF
digits (of the called number) towards the phone line.
Notes:
ƒ
The called number can include characters 'p' (1.5 seconds pause)
and 'd' (detection of dial tone). If character 'd' is used, it must be the
first 'digit' in the called number. The character 'p' can be used several
times.
For example (for FXS/FXO module), the called number can be as
follows: d1005, dpp699, p9p300. To add the 'd' and 'p' digits, use the
usual number manipulation rules.
ƒ
To use this feature with FXO gateways, configure the gateway to
operate in one stage dialing mode.
ƒ
If the parameter EnableDigitDelivery is enabled, it is possible to
configure the FXS/FXO gateway to wait for dial tone per destination
phone number (before or during dialing of destination phone number),
therefore, the parameter IsWaitForDialTone (configurable for the
entire gateway) is ignored.
ƒ
The FXS gateways send SIP 200 OK responses only after the DTMF
dialing has completed.
RTP Only Mode
[RTPOnlyMode]
Enables the gateway to start sending and/or receiving RTP packets to
and from remote endpoints without the need to establish a Control
session. The remote IP address is determined according to the Tel to IP
Routing table. The port is the same port as the local RTP port (set by
BaseUDPPort and the channel on which the call was received).
Valid options include:
ƒ
[0]
Disable = Disable (default).
ƒ
[1]
Transmit & Receive = send and receive RTP.
ƒ
[2]
Transmit Only= send RTP only.
ƒ
[3]
Receive Only= receive RTP only.
Enable DID Wink
[EnableDIDWink]
ƒ
[0]
Disable = Direct Inward Dial (DID) is disabled (default).
ƒ
[1]
Enable = Enable DID.
If enabled, the gateway can be used for connection to EIA/TIA-464B DID
Loop Start lines. Both FXO (detection) and FXS (generation) are
supported.
An FXO gateway dials DTMF digits after a Wink signal is detected
(instead of a Dial tone).
An FXS gateway generates the Wink signal after the detection of offhook
(instead of playing a Dial tone).
Delay Before DID Wink
[DelayBeforeDIDWink]
Defines the time interval (in seconds) between detection of offhook and
generation of DID Wink. Applicable only to FXS gateways.
The valid range is 0 to 1,000. The default value is 0.