AudioCodes Mediapack mp-11x, User Manual

Page: 53 / 390

Version 5.2 53 August 2007
SIP User's Manual 4. Getting Started
4.4 Configuring Basic Parameters
To configure the gateway's
basic
parameters, use the Embedded Web Server’s ‘Quick
Setup’ screen (shown in the figure below). For information on accessing the Embedded
Web Server, refer to 'Accessing the Embedded Web Server' on page
58 .
Figure 4-2: Quick Setup Screen
¾
To configure basic SIP parameters, take these 10 steps:
1.
Access the ‘Quick Setup’ screen by clicking the
Quick Setup
menu.
2.
If the gateway is connected to a router with NAT (Network Address Translation)
enabled, perform the following (if it isn’t, leave the ‘NAT IP Address’ field undefined):
•
Determine the ‘public’ IP address assigned to the router (by using, for example,
router Web management). If the public IP address is static, enter this in the ‘NAT
IP Address’ field.
•
Enable the DMZ (Demilitarized Zone) configuration on the router for the LAN port
where the gateway is connected. This enables unknown packets to be routed to
the DMZ port.
3.
Under ‘SIP Parameters’, enter the gateway's domain name in the field ‘Gateway
Name’. If the field is not specified, the gateway's IP address is used instead (default).