AudioCodes Mediapack mp-11x, User Manual

Page: 54 / 390

SIP User's Manual 54 Document #: LTRT-65409
MediaPack Series
4.
When working with a Proxy server, set the ‘Working with Proxy’ field to ‘Yes’, and then
enter the IP address of the primary Proxy server in the field ‘Proxy IP address’. When
no Proxy is used, the internal routing table is used to route the calls.
5.
Enter the Proxy name in the field ‘Proxy Name’. If Proxy name is used, it replaces the
Proxy IP address in all SIP messages. This means that messages are still sent to the
physical Proxy IP address, but the SIP URI contains the Proxy name instead.
6.
Configure ‘Enable Registration’ to either one of the following:
•
‘Disable’ = the gateway doesn't register to a Proxy server/Registrar (default).
•
‘Enable’ = the gateway registers to a Proxy server/Registrar at power up and
every ‘Registration Time’ seconds. For detailed information on the parameter
‘Registration Time’, refer to 'Proxy & Registration Parameters' on page
82 .
7.
To configure the Coders Table, click the arrow button next to ‘Coders Table’. For
information on how to configure the Coders Table, refer to 'Coders' on page
92 .
8.
To configure the Tel to IP Routing Table, click the arrow button next to ‘Tel to IP
Routing Table’. For information on how to configure the Tel to IP Routing Table, refer
to 'Tel to IP Routing Table' on page
129 .
9.
To configure the Endpoint Phone Number Table, click the arrow button next to
‘Endpoint Phone Number’. For information on how to configure the Endpoint Phone
Number Table, refer to Configuring the Endpoint Phone Numbers on page
144 .
10.
Click the
Reset
button, and then at the prompt, click
OK
; the gateway applies the
changes and restarts.
You are now ready to start configuring the gateway. To prevent unauthorized access to the
gateway, it's recommended that you change the default username and password used to
access the Embedded Web Server. Refer to 'Configuring the Web User Accounts' on page
188 on how to change the username and password.
Tip:
Once the gateway is configured correctly, back up your settings by saving a
copy of the VoIP gateway configuration (
ini
file) to a directory on your PC.
This saved file can be used to restore configuration settings at a later date.
For information on backing up and restoring the gateway's configuration, refer
to 'Restoring and Backing up Configuration' on page
240 .