AudioCodes Mediapack mp-11x, User Manual

Page: 40 / 390

SIP User's Manual 40 Document #: LTRT-65409
MediaPack Series
3.2.4 Cabling the MP-124
This section describes MP-124 cabling, which includes the following:
„ Grounding the MP-124 (refer to 'Grounding the MP-124' on page 40 )
„ Connecting MP-124 to the Ethernet network (refer to 'Connecting MP-124 to the
Ethernet Network' on page
40 )
„ Connecting MP-124 to FXS analog lines using a Telco cable (refer to 'Connecting MP-
124 to FXS Interface' on page
41 )
„ Connecting MP-124 RS-232 port to a PC (refer to 'Connecting MP-124 RS-232 Port to
a PC' on page
43 .)
„ Connecting MP-124 to the power supply (refer to 'Connecting MP-124 to Power' on
page
43 )
For detailed information on the MP-124 rear panel connectors, refer to 'MP-124 Rear
Panel' on page
28 .
3.2.4.1 Grounding the MP-124
Connect an earthed strap to the chassis protective earthing screw (6-32 UNC screw) and
fasten it securely according to the safety standards.
3.2.4.2 Connecting MP-124 to the Ethernet Network
Follow the procedure below for connecting MP-124 directly to the Ethernet network.
¾
To connect MP-124 directly to the Ethernet network:
„ Using a crossover Ethernet cable with RJ-45 connectors on either end, connect the
MP-124 Ethernet port (labeled
ETHERNET
), directly to the network. For RJ-45
connector pinouts, refer to the figure below.
Figure 3-10: RJ-45 Connector Pinouts
Note:
When assigning an IP address to the MP-124 using HTTP (refer to 'Assigning
an IP Address Using HTTP' on page 48 ), you may be required to disconnect
Ethernet cable and re-cable it differently.