AudioCodes Mediapack mp-11x, User Manual

Page: 376 / 390

SIP User's Manual 376 Document #: LTRT-65409
MediaPack Series
8.9.3.1 Integrating Using the Embedded Web Server
The procedure below describes how to integrate the gateway into a VLAN and multiple IPs
network using the Embedded Web Server.
¾
To integrate the gateway into a VLAN and multiple IPs network
using the Embedded Web Server, take these 7 steps:
1.
Access the Embedded Web Server (refer to 'Accessing the Embedded Web Server'
on page
58 ).
2.
Use the Software Upgrade Wizard ('Software Upgrade Wizard' on page 226 ) to load
and
burn
the firmware version to the gateway (VLANs and multiple IPs support is
available only when the firmware is burned to flash).
3.
Configure the VLAN parameters by completing the following steps:
a.
Open the ‘VLAN Settings’ screen (
Advanced Configuration
menu >
Network
Settings
>
VLAN Settings
option).
b.
Modify the VLAN parameters to correspond to the values shown in the following
figure.
Figure 8-2: VLAN Settings Screen - Example
c.
Click the
Submit
button to save your changes.
4.
Configure the multiple IP parameters by completing the following steps:
a.
Open the ‘IP Settings’ screen (
Advanced Configuration
menu >
Network
Settings
>
IP Settings
option).
b.
Modify the IP parameters to correspond to the values shown in the figure below.
Note that the OAM, Control, and Media Network Settings parameters appear only
after you select the options ‘Multiple IP Networks’ or 'Dual IP' in the field ‘IP
Networking Mode’.
Note:
Configure the OAM parameters only if the OAM networking parameters are
different from the networking parameters used in the Single IP Network mode.