AudioCodes Mediapack mp-11x, User Manual

Page: 180 / 390

SIP User's Manual 180 Document #: LTRT-65409
MediaPack Series
Table 5-35: Media Settings -- Fax/Modem/CID Parameters
Parameter Description
Fax Transport Mode
[FaxTransportMode]
Fax Transport Mode that the gateway uses.
ƒ
[0]
Disable = transparent mode.
ƒ
[1]
T.38 Relay = (default).
ƒ
[2]
Bypass.
ƒ
[3]
Events Only.
Note:
If parameter IsFaxUsed = 1, then FaxTransportMode is always
set to 1 (T.38 relay).
Caller ID Transport Type
[CallerIDTransportType]
Defines the Caller ID Transport type.
ƒ
[0]
Disable = Disable
ƒ
[1]
Relay = Relay
ƒ
[3]
Mute = Mute
Caller ID Type
[CallerIDType]
Defines one of the following standards for detection (FXO) and
generation (FXS) of Caller ID, and detection (FXO) generation (FXS)
of MWI (when specified) signals:
ƒ
[0]
Bellcore = Caller ID and MWI (default)
ƒ
[1]
ETSI = Caller ID and MWI
ƒ
[2]
NTT
ƒ
[4]
Britain
ƒ
[16]
DTMF ETSI
ƒ
[17]
Denmark = Caller ID and MWI
ƒ
[18]
India
ƒ
[19]
Brazil
Notes:
ƒ
Typically, the Caller ID signals are generated/detected between
the first and second rings. However, sometimes the Caller ID is
detected before the first ring signal (in such a scenario, configure
RingsBeforeCallerID to 0).
ƒ
Caller ID detection for Britain [4] is not supported on the
gateway’s FXO ports. Only FXS ports can generate the Britain [4]
Caller ID.
ƒ
To select the Bellcore Caller ID sub standard, use the parameter
'BellcoreCallerIDTypeOneSubStandard'. To select the ETSI Caller
ID sub standard, use the parameter
'ETSICallerIDTypeOneSubStandard'.
ƒ
To select the Bellcore MWI sub standard, use the parameter
'BellcoreVMWITypeOneStandard'. To select the ETSI MWI sub
standard, use the parameter 'ETSIVMWITypeOneStandard'.
ƒ
If you define NTT (i.e., 2) for the caller ID type, you need to define
the NTT DID signaling form (FSK or DTMF) using
NTTDIDSignallingForm.