AudioCodes Mediapack mp-11x, User Manual

Page: 150 / 390

SIP User's Manual 150 Document #: LTRT-65409
MediaPack Series
Notes:
•
After a ring signal is detected on an 'Enabled' FXO port, the gateway
initiates a call to the destination number without seizing the line. The line
is seized only after the call is answered.
•
After a ring signal is detected on a 'Disabled' or 'Hotline' FXO port, the
gateway seizes the line.
5.5.8.3 Caller ID
The 'Caller Display Information' screen is used to send (to IP) Caller ID information when a
call is made using the gateway (relevant to both FXS and FXO). The person receiving the
call can use this information for caller identification. The information in this screen (table) is
sent in an INVITE message in the 'From' header. For information on Caller ID restriction
according to destination / source prefixes, refer to 'Configuring the Number Manipulation
Tables' on page
121 .
You can also configure the Caller Display Information table using the
ini
file parameter
CallerDisplayInfo (refer to 'Analog Telephony Parameters' on page 294 ).
Note:
If Caller ID name is detected on an FXO line (EnableCallerID = 1), it is used
instead of the Caller ID name defined in this table (FXO gateways only).
¾
To configure the Caller Display Information, take these 6 steps:
1.
Open the 'Caller Display Information' screen (
Protocol Management
menu >
Endpoint Settings
submenu >
Caller ID
option).
Figure 5-30: Caller Display Information Screen