AudioCodes Mediapack mp-11x, User Manual

Page: 148 / 390

SIP User's Manual 148 Document #: LTRT-65409
MediaPack Series
5.5.8 Configuring the Endpoint Settings
The
Endpoint Settings
submenu enables you to configure port-specific parameters.
5.5.8.1 Authentication
The 'Authentication' screen (typically used for FXS gateways) defines a username and
password combination for authenticating each gateway port.
The 'Authentication Mode' parameter (described in 'Proxy & Registration Parameters' on
page
82 ) determines whether authentication is performed per port or for the entire
gateway. If authentication is performed for the entire gateway, this table is ignored.
You can also configure Authentication using the
ini
file parameter table Authentication
(refer to 'SIP Configuration Parameters' on page 279 ).
Note:
If either the username or password field is omitted, the port's phone number
(defined in Configuring the 'Endpoint Phone Numbers' on page 144 ) and
global password (refer to the parameter 'Password' described in 'Proxy &
Registration Parameters' on page
82 ) are used instead.
¾
To configure the Authentication Table, take these 6 steps:
1.
Set the 'Authentication Mode' parameter to 'Per Endpoint' (refer to 'Proxy &
Registration Parameters' on page
82 ).
2.
Open the 'Authentication' screen (
Protocol Management
menu >
Endpoint Settings
>
Authentication
option).
3.
In the 'User Name' and 'Password' fields for a port, enter the username and password
combination respectively.
4.
Repeat Step 3 for each port.
5.
Click the
Submit
button to save your changes.
6.
To save the changes to flash memory, refer to 'Saving Configuration' on page 238 .