AudioCodes Mediapack mp-11x, User Manual

Page: 154 / 390

SIP User's Manual 154 Document #: LTRT-65409
MediaPack Series
¾
To configure Call Waiting, take these 5 steps:
1.
Open the 'Caller Waiting' screen (
Protocol Management
menu >
Endpoint Settings
>
Call Waiting
option).
Figure 5-33: Call Waiting Screen
2.
For each relevant, from the 'Call Waiting Configuration; drop-down list, select one of
the following:
•
'Enable': Enables call waiting for the specific port. when an FXS gatewaymodule
receives a call on a busy endpoint, it responds with a 182 response (and not with
a 486 busy). The gateway plays a call waiting indication signal. When hook-flash
is detected, the gateway switches to the waiting call. The gateway that initiated
the waiting call plays a Call Waiting Ringback tone to the calling party after a 182
response is received.
•
'Disable': No call waiting for the specific port.
•
Empty: Call waiting is determined according to the global (i.e., for all ports)
parameter EnableCallWaiting (described in 'Supplementary Services' on page
108 ).
3.
Repeat Step 2 for each port.
4.
Click the
Submit
button to save your changes.
5.
To save the changes to flash memory, refer to 'Saving Configuration' on page 238 .
5.5.9 Configuring the Advanced Applications
The
Advanced Applications
submenu enables you to configure advanced applications
such as RADIUS.
5.5.9.1 Configuring RADIUS Accounting Parameters
The 'RADIUS Parameters' screen is used for configuring the Remote Authentication Dial In
User Service (RADIUS) accounting parameters.