AudioCodes Mediapack mp-11x, User Manual

Page: 158 / 390

SIP User's Manual 158 Document #: LTRT-65409
MediaPack Series
Table 5-27: FXO Parameters
Parameter Description
Ring Detection Timeout
[sec]
[FXOBetweenRingTime]
Note:
Applicable only to FXO gateways for Tel Æ IP calls.
The Ring Detection timeout is used differently for normal and for automatic
dialing.
If automatic dialing is not used, and if Caller ID is enabled, then the FXO
gateway seizes the line after detection of the second ring signal (allowing
detection of caller ID, sent between the first and the second rings). If the
second ring signal doesn't arrive for 'Ring Detection Timeout' the gateway
doesn't initiate a call to IP.
When automatic dialing is used, the FXO gateway initiates a call to IP
when ringing signal is detected. The FXO line is seized only if the remote
IP party answers the call. If the remote party doesn't answer the call and
the ringing signal stops for 'Ring Detection Timeout', the FXO gateway
Releases the IP call.
Usually set to a value between 5 and 8. The default is 8 seconds.
Reorder Tone Duration
[sec]
[TimeForReorderTone]
Busy or Reorder tone duration (seconds) the FXO gateway plays before
releasing the line.
The valid range is 0 to 100. The default is 0 seconds
Usually, after playing a Reorder / Busy tone for the specified duration, the
FXS gateway starts playing an Offhook Warning tone.
Note 1:
Selection of Busy or Reorder tone is performed according to the
release cause received from IP.
Note 2:
Refer also to the parameter 'Enable Calls Cut Through'
(CutThrough) (described in 'General Parameters' on page 100 ).
Answer Supervision
[EnableVoiceDetection]
ƒ
[1]
Yes = FXO gateway sends 200 OK (to INVITE) messages when
speech/fax/modem is detected.
ƒ
[0]
No = 200 OK is sent immediately after the FXO gateway finishes
dialing (default).
Usually this feature is used only when early media is used to establish
voice path before the call is answered.
Note:
This feature is applicable only to 'One Stage' dialing for FXO
gateways.
Rings before Detecting
Caller ID
[RingsBeforeCallerID]
Sets the number of rings before the gateway starts detection of Caller ID
(FXO only).
ƒ
[0]
0 = Before first ring.
ƒ
[1]
1 = After first ring (default).
ƒ
[2]
2 = After second ring.
Send Metering Message
to IP
[SendMetering2IP]
N/A.
Disconnect on Busy Tone
[DisconnectOnBusyTon
e]
ƒ
[0]
No = Do not disconnect call on detection of busy tone (FXO
gateway).
ƒ
[1]
Yes = Call is released (on FXO gateway) if busy or reorder (fast
busy) tones are detected on the gateway's port (default).