Anritsu MX183000A, Operation Manual, Page: 76 / 226

Chapter 4 Operation
4-22
Table 4.5.2-1 USB Link Sequence Setting Items
Item Description
USB3.1 Specification Selects and sets the USB specification from Gen1(5.0
GT/s) and Gen2(10.0 GT/s).
If MU181000A/B is installed, set the 32G PPG
Operation Bitrate to Gen1:5.0 GT/s and Gen2:10 GT/s
respectively.
Altering this item changes the sequence displayed in
Sequence Editor.
Test Pattern Selects the test pattern output repeatedly from
Compliance or USER after completing the link training
sequence transmission.
Selecting Compliance displays the USB standard test
pattern selection controller. Selecting USER
automatically sets a test pattern specified for 32G PPG
on the MX180000A.
If Compliance is set, the pattern is set automatically in
accordance with 32G PPG.*
Selectable value changes depending on the value set for
USB 3.1 Specification.
Transmit/Stop Starts sending a pattern selected at Test Pattern.
The button display is changed to Stop while the pattern
is sent.
When Stop is clicked, sending the pattern is stopped.
When Sequence Start is clicked, sending the pattern is
stopped automatically. The button display is changed to
Transmit.
Add Single Bit Error Inserts a 1-bit error to the sending pattern.
This function is enabled in one of the following
conditions.
•
Gen1(5.0 GT/s), Compliance, CP0
•
Gen2(10.0 GT/s), Compliance, CP9
TS Option Enables the setting screen display and setting status for
the USB Link Sequence in Figure 4.5.2-2to be altered.
*: Selecting CP5 or CP6 does not change de-emphasis setting that is
actually output.