Anritsu MX183000A, Operation Manual, Page: 213 / 226

Appendix A Specifications
A-7
A
pp
en
dix
A
ppe
ndi
x A
Table A-6 Sequence Tab (USB)
Item Specifications
LTSSM State
Sequence Start/Stop/Unlink eSS.Inactive, Rx.Detect, Polling, Loopback
Sends the sequence set by Editor. Starts sending a sequence when
a trigger is detected by Aux Input of the MU183020A. Continues
sending test patterns after a link sequence is sent.
USB3.1 Specification
Test Pattern
CPx
All parameter
Default
Sequence Editor
Gen1
Rx.Detect.Active(Idle)
Polling.LFPS
Polling.RxEQ
Polling.Active(TS1)
Polling.Configuration(TS2)
Polling.Idle
Gen2
Rx.Detect.Active(Idle)
Polling.LFPS(SCD1)
Polling.LFPSPlus(SCD2)
Polling.PortMatch
(PHY Capability LBPM)
Polling.PortConfig
(PHY Ready LBPM)
Polling.RxEQ
Polling.Active(TS1)
Polling.Configuration(TS2)
Polling.Idle
Gen1(5 GT/s), Gen2(10 GT/s)
Compliance/USER
Gen1: CP0 D0.0, CP1 D10.2, CP2 D24.3, CP4 LFPS,
CP5 K28.7*, CP6 K28.7*
Gen2: CP9
Displays all sequence setup parameters.
Initialize sequence setting.
Sets a pattern number to send in each state or sets idle time.
1 to 000000, 1 step
100 to 000000, 10 step
1 to 1000000, 1 step
1 to 1000000, 1 step
1 to 1000000, 1 step
1 to 1000000, 1 step
1 to 1000000, 1 step
162 to 1000000, 1 step
172 to 1000000, 1 step
2 to 1000000, 1 step
2 to 1000000, 1 step
1 to 1000000, 1 step
1 to 1000000, 1 step
1 to 1000000, 1 step
1 to 1000000, 1 step
*: Selecting CP5 or CP6 does not change de-emphasis setting that is
actually output.