Anritsu MX183000A, Operation Manual, Page: 50 / 226

Chapter 3 Connecting Equipment
3-12
17. Select MU181000A/B for Clock Source for the MU181500B.
3.3 “Input Signal Settings” in the MU181500B Jitter Modulation
Source Operation Manual
18. Select MU181500B in Clock Setting of the Misc2 tab of
MU183020A-x30.
5.6 “Misc2 Function” in the MU183020A 28G/32G PPG MU183021A
28G/32G 4ch PPG Operation Manual
19. On the Misc2 tab of MU183020A-x30, select Full Rate in the Output
Clock Rate box.
5.6 “Misc2 Function” in the MU183020A 28G/32G PPG MU183021A
28G/32G 4ch PPG Operation Manual
20. Select the PPG connected for MP1825B-x02 Data Input.
3.3 “Input Signal Settings” in the MP1825B 4Tap Emphasis Operation
Manual
21. Select Full Rate for MP1825B-x02 Clock Input.
3.3 “Input Signal Settings” in the MP1825B 4Tap Emphasis Operation
Manual
22. Connect the Compliance Base Board output (Tx Out) to a real-time
oscilloscope, and calibrate the Eye Pattern (amplitude, Jitter, and
Emphasis settings).
23. Once Eye Pattern calibration is complete, connect the Compliance
Base Board output (Tx Out) to the MU183040B-x22 Data Input and
Data
Input connector with an 80 cm coaxial cable (J1551A).
24. Select Recovery Clock from Clock Setup Selection in the
MU183040B-x22 Input tab.
5.4 “Input Signal Settings” in the
MU183040A/MU183041A/MU183040B/MU183041B Operation Manual
CAUTION
The SMP connector can withstand 100 insertion/removal
cycles. Do not exceed this limit when you need to insert
and remove the connector repeatedly. Exceeding the limit
may cause performance deterioration by contact failure or
connector damage.