Zontes ZT350-EURO V 2022, Руководство по обслуживанию

Страница: 98 / 118

11-FUEL TANK LINER ASSEMBLY
97
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1224100-033000 ZT250-S thread cap of the fuel tank 1
2 4034200-009000 ZT310-T fuel tank liner 1
3 1244100-002000 ZT250-S Side cover round rubber 4
4 1240300-021000 HJ125-6 pod glass strip (1.5m) 1
5 1250105-137093 GB5789M6×16 (environmental color) 8
6 1050958-013000 T02 built-in fuel pump (ZT350-T) 1
PROCEDURE:
●
Fuel tank cap
Pinch
①
and turn it counterclockwise to remove the fuel tank cap
⑴
, be careful not to pull the nylon rope
②
with force. The newly purchased fuel tank cap needs to remove the bushing indicated by the arrow before use,
otherwise the expansion nail cannot be inserted into the fixed nylon rope.
●
Adhesive strip
There is a 0.4m rubber strip
⑷
at the front of the fuel tank and a 0.2m rubber strip
⑷
on the right side. Just
pull it off with your hands from one end of the tape.
●
Side cover round rubber
Remove the side cover rubber
⑵
from the fuel tank liner
⑶
.
●
Fuel pump
Invert the fuel tank liner assembly and place it firmly, then use a 10# sleeve to remove the bolt
⑸
.
When removing the fuel pump
⑹
, do not bend or bend the connecting rod of the float to avoid inaccurate
display of the fuel quantity.
After removing the fuel pump, it is recommended to temporarily seal the fuel pump port and pay attention to
prevent bumping. Prevent foreign objects from falling into the fuel tank.
CAUTION:
●
Before dismantling the fuel tank liner assembly, it is recommended to use the fuel pump to pump out the fuel
or to disassemble the fuel after the fuel is consumed.
●
No fireworks, answering or making phone calls, etc. should be strictly prohibited near the dismantling site to
prevent accidents.
●
Be sure to check whether the fuel tank cap has been tightened by inverting the fuel tank liner assembly to
remove the fuel pump to prevent residual fuel from overflowing from the fuel tank port; a small amount of fuel
may overflow from the vent pipe
②
when the fuel tank cap is turned over and removed.
●
When reassembling the fuel pump, be sure to clean up the fuel pump gasket and the joint surface of the fuel
tank liner. When tightening the bolts, stagger the positions and lock them to ensure that the gasket is evenly
deformed.
Fig.3 FUEL TANK LINER
ASSEMBLY
Bile in the fuel tank