Zontes ZT350-EURO V 2022, Руководство по обслуживанию

Страница: 83 / 118

8-FRONT FORK COMPONENT
82
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1251100-112000 Disc brake pipe bolt M10×1
－
22 1
2 1251513-013000 Disc brake pipe copper washer φ 15× φ 10.2 × 1.5 2
3 1100100-831000 ZT350-GK front disc brake main pump assembly (φ14) 1
PROCEDURE:
●
Release brake fluid
Referring to the previous steps of adding brake fluid, remove the upper cover, cover plate and sealant pad of
the oil cup of the front and rear disc brake main pump respectively.
Place holder to collect wasted brake fluid under the ABS hydraulic control unit.
After wearing waterproof gloves, pull out the hydraulic control unit and tilt it to the right, and loosen the nut
joints of 4 oil pipes with an open-ended wrench. After draining the brake fluid, remove the hydraulic control
unit and wipe off the oil stain. Be careful not to let the brake fluid contact the cable connector to prevent poor
contact due to corrosion.
RC-HU is connected to the hydraulic control unit and rear brake caliper; RMC-HU is the rear disc brake main
pump; FC-HU is the front disc brake caliper; FMC-HU is the front disc brake main pump.
●
FMC-HU oil pipe
The oil pipe, front disc brake main pump, rocker arm assembly and disassembly refer to the previous steps in
"Adding brake fluid and rocker arm adjustment".
CAUTION:
●
Be sure to disassemble the muffler and engine after they have cooled down completely. The horizontal support
of thevehicle should be fixed before disassembly and assembly work.
●
The precautions for brake fluid are described in the previous section.
●
It is recommended to replace the two copper washers
⑵
at the same timewhen replacing the tubing. The bolts
⑴
needn't to be replaced if they are not damaged.
Fig.28 FRONT FORK
COMPONENT
ABS brake system A-2