Zontes ZT350-EURO V 2022, Руководство по обслуживанию

Страница: 85 / 118

8-FRONT FORK COMPONENT
84
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1251513-013000 Disc brake pipe copper washer φ 15× φ 10.2 × 1.5 4
2 1251100-112000 Disc brake pipe bolt M10×1
－
22 1
3 1251112-001093 M6×16 Hexagon flange bolts (color zinc) 2
4 1251100-101000 Non-standard bolt M6×12 (304 stainless steel) 1
5 1224200-003000 ZT310-R Rear disc brake pipe clamp 2
6 1251100-102000 Non-standard bolt M6×16
（
304 stainless steel
）
3
7 1181200-118000 Wheel speed sensor
（
A
）
1
8 1224100-044000 Wheel speed sensor clamp 3
Fig.30 FRONT FORK
COMPONENT
Double Rock Ace ABS Brake System A-4
PROCEDURE
：
●
RMC-HU oil pipe
Find and unplug the brake switch cable plug.
Remove the main pump of rear disc brake according to the steps of "right foot pedal support assembly 1" and
"right foot pedal support assembly 2".
After wearing waterproof gloves, remove the oil cup cover and pour out the brake fluid according to the
previous steps of adding the brake fluid of the rear disc brake main pump. Loosen the brake switch nut with
14# an open-ended wrench. Remove the copper gasket
⑴
and rmc-hu oil pipe.
●
Wheel speed sensor
First, refer to the steps of removing the "muffler" to remove the rear section of the muffler, find the cable
connector of wheel speed sensor
⑺
and then unplug it. Remove three wheel speed sensor wire clamps
⑻
. Pull
the sensor wire out of the two disc brake oil pipe clamps
⑸
.
Remove one bolt
⑹
at the caliper with 4# hexagon socket, pull off the exhaust rubber cap and remove the
sensor wire.
●
Rear disc brake caliper
Remove the rear wheel caliper assembly from the front of the right rear wheel according to the steps. Put the
rear axle, right chain adjuster and rear axle nuts back into the rear flat fork first.
●
RC-HU oil pipe
Place the oil pan under the rear disc brake caliper.
After wearing waterproof gloves, remove bolts
⑵
with 12# sleeves; Remove the copper washer
⑴
. If rc-hu oil
pipe needs to be replaced, it is recommended to replace two copper washers
⑴
at the same time;
⑵
if the bolt is
not damaged, it can not be replaced.
CAUTION:
●
The precautions for brake fluid are described in the previous section.
●
It is recommended to replace two copper washers
⑴
at the same time when replacing the oil pipe, rear brake
switch wire or disc brake main pump.