Zontes ZT350-EURO V 2022, Руководство по обслуживанию

Страница: 116 / 118

16-MUFFLER COMPONENT
115
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1050970-011000 LSF oxygen sensor(L=635mm) 1
2 1276200-043000 φ6 wire clamp (L=57) 2
3 1250205-023000 GB70.1 inner hexagonal M8×35 (color Zinc) 1
4 1274100-074000 ZT310-R Muffler stainless steel bar clasp 1
5 1250205-125000 GB70.2 M8×35(12.9 garde,darco) 1
7 1124300-004000 ZT350-GK muffler graphite gasket(37.8×28×11) 1
PROCEDURE:
●
The muffler component refers to the "front encirclement component" steps to remove the surround component
and the underwritten hood component.
Put down the side frame.
The two threads shown in the figure are removed. Find the plug of the oxygen sensor in the upper part of the
right guard, and press the buckle indicated by the A arrow in one hand to pull the plug into the direction of the
arrow B.
●
Muffer rear assembly
Remove the bolt
⑶
wiht 6# inner hexagon socket and remove clamp
⑷
.
After support the muffer rear assembly then remove the bolt
⑸
wiht 6# inner hexagon socket,take off the
bushing
⑹
,remover the muffer rear assembly from the vehicle.
Take off the graphite gasket
⑺
,protect the nozzle,if it's deformed,it may cause leakage.The graphite gasket may
be left in teh rear assembly or in the front assembly when removed.
CAUTION:
●
The parts should be protected during disassembly to prevent damage to the paint.
●
The muffler should be completely cooled before it is disassembled.
●
Prevent foreign matter from entering the interior of the muffler.
●
The muffler nozzle needs to be protected. If there is any deformation, it may cause air leakage.
●
It is recommended that new seals be replaced each time the muffler front assembly is removed to prevent
airleakage.
Fig.1 MUFFLER
COMPONENT
Muffler component 1
6 1020243-097000
ZT350 muffler flanging bushing (φ8.3×φ11.5×20.5×φ
8.4×φ33×1.5)
1