Zontes ZT350-EURO V 2022, Руководство по обслуживанию

Страница: 63 / 118

8-FRONT FORK COMPONENT
62
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1
ZT350-GK front radial caliper brake pads (SBS-SI-
104HH)
After-sales 1100100-827000 1
PROCEDURE:
●
Replace the front brake
Replace the front brake tablet with a sharp mouth tong and pull out the stuck spring
①
, remove the two card
springs.
Use the T25 hexagonal plum wrench to remove the sales axis above
②
, and then remove the sales axis.
Remove the shot
③
, remove the brake piece
⑴
.
Clean up foreign bodies such as the outer edge of the piston and the shaft.
Use a cross screw knife to remove the bolt of the first disc brake main pump.
Push the piston to the end in the direction of the arrow.
The main pump assembly of the front disc brakes must be accurately assembled.
Put the two brake slices in the calipers and install the shot
③
to the middle of the two brake films. The direction
of the arrows in the shifts should be above.
Press the shell pointed at the arrows in the direction of the arrow with your hands, and insert the axis
②
to
insert the hole to fix the brake tablet. Tighten the axis on the T25 hexagonal plum wrench.
Use your hand to hold the body pointed at the arrow in the direction of the arrow, and use the sales axis
②
to
insert the hole to fix the brake tablet. Tighten the axis on the T25 hexagonal plum wrench.
Put the two card springs back on the sales axis. The buckle is in place after making a sound. When assembling
the deck, you need to pay attention to the edge of the edge. If the deformation of the deformation can be
corrected with a hammer with appropriate strength.
Repeat the handle until the power is resumed.
CAUTION:
●
The vehicle should be fixed and then operated.
●
Check the wear of braking films and brake discs regularly, and regularly check whether the brake liquid
surface in the dish main pump is 3/4.
●
When replacing the brake film, it is strictly forbidden to remove the oil pipe bolt and the bolt of the air -to -
mouth.
●
After disassembling the main pumping cup cover of the disc brake, the car should not shake the front to
prevent the brake from overflowing.
●
After newly replaced the brake film, it should be fully running in before the brake can be fully run into the best
braking effect.Pay attention to leaving enough braking distance during the running -in.
●
It is recommended to go to a qualified maintenance unit to replace the brake film.
Fig.8 FRONT FORK
COMPONENT
Replace the front brake