Zontes ZT350-EURO V 2022, Руководство по обслуживанию

Страница: 35 / 118

5-SINGLE ROCKER COMPONENT
34
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1250104-006097 GB16674M6×12 (chromed/HH) 3
2 1274100-057095 Flanging bushing φ6.2×φ8.4×3.5
＋
φ14×1.5 5
3 1244100-052000 Buffer rubber of flanging bushing
（
φ8.5×φ14×1
）
5
4 1251100-102000 Non-standard bolt M6×16
（
304 stainless steel
）
2
5 1210342-424000 ZT310 rear inner mud board decal (RACING) 1
6 1224300-087000 ZT350-R1 rear inner mud plate 1
7 1210343-056000 ZT350-GK chain decal 1
PROCEDURE
：
●
Rear mud board
Extend the 8# sleeve into the gap above the right front of the rear inner mud plate, remove the bolt
⑴
, and
remove the bushing
⑵
and buffer rubber
⑶
.
Remove the bolt
⑷
on the right side with 4# hexagon socket, and remove the bushing
⑵
and buffer rubber
⑶
.
Use 8# sleeve to remove the bolt
⑴
at the front of the left inner side, and remove the bushing
⑵
and buffer
rubber
⑶
.
Remove the bolt
⑴
at the rear of the left side with 8# sleeve, and remove the bushing
⑵
and buffer rubber
⑶
.
Hold the rear inner mud plate
⑹
, remove the bolt
⑷
above the left front with 4# inner hexagon, and remove the
bushing
⑵
and buffer rubber
⑶
.
The applique
⑸
and the chain decal
⑺
can be heated back and forth by a hot air gun, and the applique is torn
off from the inner mud plate after the heat viscosity is lowered.
CAUTION:
●
When heating and tearing the applique, be careful not to align the same part for a long time to prevent damage
to the inner mud board.
Fig.9 REAR WHELL
COMPONENT
Rear mud board