Zontes ZT350-EURO V 2022, Руководство по обслуживанию

Страница: 51 / 118

7-COOLING SYSTEM COMPONENT
50
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1274300-024000 ZT350-R right water tank 1
2 1244100-002000 ZT250
－
S Side cover round rubber 2
3 1251100-061093 M6×22 Hex flang bolt thread level 8.8 (color zinc) 3
4 1274200-089000 ZT310 water pipe clamp
（
φ22
）
2
5 1244300-010000 ZT350-R auxiliary water tank connecting water pipe 1
6 1274200-079000 ZT310 water pipe clamp
（
φ9
）
1
7 1244300-009000 ZT350-R water inlet connection water pipe 1
8 1244200-011000
ZT310
－
R connecting water pip of left and right water tank
1
9 1244200-021000 ZT310
－
R small cyclic water pipe 1
10 1274200-041000 ZT310 Water pipe clamp
（
φ26
）
3
11 1244200-012000 ZT310
－
R water pipe of engine 1
12 1244200-098000 ZT310-R engine inlet pipe (sliding clutch) 1
13 1274200-041000 ZT310 Water pipe clamp
（
φ26
）
3
14 1224300-112000 ZT350
－
X wheel speed sensor plug holder
1
PROCEDURE
：
●
Sub water tank connecting tube
Use a plier to clamp the hoop of water tube
⑴
and move towards right water tank. After it is off from the
connecting tube of sub water tank
⑸
, pull off the tube
⑸
.
●
Connecting water pipes of left and right water tanks
Clamp the hoop
⑽
and move it out of the water pipe joint towards the water tank, and separate the left and
right water tank connecting pipes
⑻
from the right water tank assembly. Separate the small circulating water
pipe
⑼
from the water tank assembly in the same way.
●
Right water tank assembly
Clamp the hoop
⑷
and move it out towards the water inlet connecting pipe
⑺
, and separate the water inlet
connecting pipe
⑺
from the right water tank assembly. Clamp the hoop
⑽
at the engine water inlet pipe
⑿
,
move it out towards the water pipe, and separate the engine water inlet pipe
⑿
from the right water tank
assembly. Unplug the water tank fan connectors
①
and
②
, remove three bolts
⑶
with 8# sleeves, and
remove the right water tank. Remove two pieces of side cover round glue
⑵
from the right water tank
⑴
.
●
Engine water pipe
Loosen the clamp
⒀
at both ends of the water pipe
⑾
with a slotted screwdriver, move it out of the anti
detachment boss, pull it off the engine and remove the clamp
⒀
.
Loosen the bolt of clamp
⒀
with a slotted screwdriver, remove the raised part of the water pipe joint, and
pull out the water pipe
⒀
from the water pipe joint of the right engine box cover.
CAUTION:
●
Manipulation should start after the engine is completely cooled down.
●
Do not disassemble the hoop with too strong force. If not, it will cause permanent deformation and lose
elasticity, which will lead to leakage of cooling liquid.
Fig.5 COOLING SYSTEM
COMPONENT
Water tank assembly 1