Zontes ZT350-EURO V 2022, Руководство по обслуживанию

Страница: 54 / 118

7-COOLING SYSTEM COMPONENT
53
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1251100-061093 M6×22 Hex flang bolt thread level 8.8 (color zinc) 3
2 1251112-001093 M6×16 Hexagon flange bolts (color zinc) 2
3 1244300-007000 ZT350-GK oil outlet pipe of engine 1
4 1244300-008000 ZT350-GK oil inlet pipe of engine 1
5 1051454-025000 9.8×2.4 Hydrogenated nitrile rubber O-ring 4
6 1274300-022000 ZT350 oil cooler 1
7 1274300-036000 ZT350-R upper bracket of oil cooler 1
8 1251112-002093 M6×30 Hexagon flange bolts (color zinc) 1
Fig.8 COOLING SYSTEM
COMPONENT
Oil cooler component 1
PROCEDURE:
●
Oil cooler component
First drain the oil according to the steps of "Change engine oil".
Place the oil receiving pan under the oil cooler, first remove the bolt
⑵
on the oil outlet pipe
⑶
with 8# sleeve,
then remove the bolt
⑴
on the oil inlet pipe
⑷
, and drain the oil in the oil cooler
⑹
.
Then remove the remaining 1 bolt
⑵
and 1 bolt
⑴
fixing the oil pipe, and remove the oil inlet pipe
⑷
, oil outlet
pipe
⑶
and O-ring.
Remove one bolt
⑻
and one bolt
⑴
fixing the oil cooler with 8# sleeve, pull down the oil cooler
⑹
and pour out
the residual oil.
CAUTION:
●
Remove the lower shroud and hydraulic control unit component first.
●
Disassembling the cooling system while the motorcycle is hot is prohibited. Wait until the engine and muffler
cool down thoroughly for the manipulation.
●
Wasted engine oil should be collected and hand over to qualified facilities for further treatment. Do not pour
the oil anywhere and avoid pollution of environment and water source.
●
Do not disassemble the oil tube violently in case of deformation of bush.
●
To avoil leakage, changing seal gasket and O-ring every time together with engine oil is suggested.
●
Be sure to wipe the connecting surface with clean nonwoven before reassembling.