Zontes ZT350-EURO V 2022, Руководство по обслуживанию

Страница: 56 / 118

8-FRONT FORK COMPONENT
55
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1154300-004000 ZT350-X throttle refueling cable 1
2 1154300-005000 ZT350-X throttle return cable 1
3 1154300-007000 ZT350-X clutch cable 1
Fig.1 FRONT FORK
COMPONENT
Throttle/clutch cable gap adjustment, high light
adjustment
PROCEDURE:
●
Adjust the throttle line
The throttle line is loosened by the open wrench to release the throttle
⑴
or the cord
⑵
. The tight nut
①
, rotate
the adjustment screw
②
adjust the gap to 2 to 4mm. After the adjustment is adjusted, the nut is locked
①
.
●
clutch rosor free itinerary
Micro -adjustment of clutch line:
The protective rubber sleeve of the clutch arm is retracted to the bending tube of the clutch line, and the nut was
loosened with pliers, the screw is adjusted by rotating, and the nut was locked. After adjustment, pay attention to
the nut
③
, adjust the screw
④
the groove of the rocker arms should be staggered to prevent the tacha from
getting out.
Great adjustment:
If the fine -tuning cannot meet the requirements, the nut was opened with the opening wrench, the screw is
adjusted by rotating, and the nut is locked again.
●
light adjustment
Lighting highly adjusts the driver to take the vehicle to correct the vehicle to find the other person to find the
lighting knob under the head to adjust the light to the right height.The counterclockwise to lower the height of the
light.
CAUTION:
●
During the disassembly process, the vehicle should be fixed to prevent accidental accidents.
●
Pay attention to the tissue adjustment of the throttle is as follows:
After the adjustment, the throttle should be automatically reset. It is strictly forbidden to increase the engine idle
due to adjustment.
When the direction of the rotation, the engine does not rise.
Check the engine idle speed of the heat machine, and should be 1500-1700 rpm.
●
Patchomer adjustment needs to be noticed as follows:
Excessive free strokes easily cause clutch and transformer mechanism wear and failure.
After adjustment, you must stagge the slot on the nuts, adjust the screw and the grooves on the rocker to prevent
the pull from getting out of the slot.
●
The height of the light needs to be paid attention to:
The height of the light is too low or too high will affect safety driving. The height of the light should be
rationally adjusted according to the changes in the weight of the crew and driver.
It is strictly forbidden to adjust the height of the light during cycling. It is recommended to find a flat road
surface with a flat road and a straight line distance of about 150 meters under the premise of affecting traffic
safety at night.