Zontes ZT350-EURO V 2022, Руководство по обслуживанию

Страница: 62 / 118

8-FRONT FORK COMPONENT
61
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1100100-833000 ZT350-GK front brake handle (CNC) 1
2 1100100-831000 ZT350-GK front disc brake main pump assembly (φ14) 1
3 1251513-013000 Disc brake pipe copper washer φ 15× φ 10.2 × 1.5 2
4 1251100-112000 Disc brake pipe bolt M10×1-22 1 32N.m
Add dynamic fluid, rocker arm adjustment
●
It is strictly forbidden to rinse the oil cup with high pressure water.
●
It is strictly forbidden to mix water, dust, impurities, and liquids of silicic acid or oil, otherwise it will
cause serious damage to the braking system.
●
After opening, it must be used in time, and it must be sealing and moisture -proof measures when
preservation; it is recommended not to exceed 1 month.Bad oil that is inferior or moisture will cause poor
braking systems, and the braking failure may cause the braking failure when it is serious. Please go to the
maintenance store with brake oil replacement equipment and technology to replace the brake oil to avoid
the braking pipeline to enter the air.
PROCEDURE:
●
The main pump
The main pump of the front disc brake is fixed with the main pump of the front disc brake, and the bolt
⑷
and
copper pad are removed with the sleeve.When replacing, you must keep the oil pipe joints always at a high level
to prevent the air from entering the pipeline to cause the brakes to fail. At the same time, it should be cleaned up
to prevent parts such as dripping to the cover parts or muffler. After replacement, you must continue the handle
of the handle. Lightly shoot the main pump of the disc brake at the same time to eliminate a small amount of gas
entering the brake oil road, and confirm that the braking is returning to normal.
●
Handle
The handle rotates and adjusts the nut.
If you need to replace the handle, use a 5 #s hexagonal tool to fix the bolt
④
, and then remove the nut with the
10#sleeve or plum blossom wrench; remove the bolt
④
and then remove the handle.
●
Adding dynamic fluid of the front disc
Check whether the brake liquid surface should be above the "LOWER" standard before adding a brake liquid.
Wait, if other abnormalities are excluded, the brake liquid needs to be added.
Only after the vehicle is fixed and the vehicle can only be added.
Remove the bolt with a cross screw knife
①
, remove the upper cover
②
, cover board
③
, and sealing rubber
pad.
Add DOT4 brake fluid to 3/4 of the transparent observation window of the main pump of the front disc brake.
Be sure to clean up the foreign body before re -assembly.
CAUTION:
●
The vehicle level should be fixed and checked before checking.
●
Seeing whether the liquid surface of the brake fluid should be regularly inspected whether the observation
window is 3/4.
●
If the liquid surface is under "LOWER", the braking film wear and the braking system should be checked first.
●
If you swallow the brake liquid, you should immediately contact the Poison Control Center or Hospital;
●
The brake liquid must stay away from children and pets.
Fig.7 FRONT FORK
COMPONENT