Zontes ZT350-EURO V 2022, Руководство по обслуживанию

Страница: 38 / 118

5-SINGLE ROCKER COMPONENT
37
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1100100-092000 ZT250-S rear disk brake pads (HS10) 1 After-sale
PROCEDURE
：
●
Disassemble disc brake arrester
Loosen the upper sliding shaft
①
with a 14# sleeve.
Loosen the lower sliding shaft
②
with a 12# ring wrench.
Remove the sliding shaft and remove the rear brake caliper.
Remove the nut
③
with a slotted screwdriver.
Remove the pin shaft
④
with 5# hexagon socket.
Take off rear disc brake arrester
⑴
.
●
Change rear disc brake arrester
Put the piston of clamp towards the direction of arrow to the end. See photo left below. To reduce resistance,
you can disassemble the cross bolt on rear disc brake main pump oil cup. Take off the top cover and sealing
gasket. Remember to rebound the pister afterwards.
The new arrester must fit tightly the slot. See photo right below.
Lock the pin shaft
④
with 5# hexagon socket.
Lock the nut
③
with a slotted screwdriver.
Lock the upper sliding shaft
①
with 14# sleeve and the torque is 34n m
。
Lock the lower sliding shaft
②
with 12# ring wrench.
Step on braking pedal several times until braking force is recovered.
CAUTION:
●
Check regularly the arrester and disc brake plate status.
●
To change arresters in qualified mainenance spot are suggested.
●
After changing the arrester, adjust the height of braking pedal according to "Foot pedal, gear shift rod
assembly" if necessary.
●
It needs running-in for about 300km after changing new arresters. During this period, leave enough braking
distance while riging.
Fig.12 REAR WHELL
COMPONENT
Change rear brake arresters