Ziton ZP3, Установка, эксплуатация и обслуживание

Страница: 169 / 239

ZP3 Fire Control Panel
Operators Instructions
ZP3 Fire Control Panel Manual
UD1160.O Iss 6 (25/02/2005)
Page 1 - 9
I
O
1.3.6 Main Operating Controls
Five controls are used to operate the system, as shown below. The operation of each
control is described.
Accept Button
After receipt of an alarm, pressing the "Accept" button causes the illuminated indicators to go
steady, and silences the panel buzzer.
Reset Button
Pressing the "Reset" button clears all alarms from the system, and restores the panel to a
normal non-alarm condition. All alarms displayed are removed, and all illuminated indicators
are switched off. Sounders are switched off, and the remote manned centre alarm is
restored to a "no-alarm" condition. If any sensors, callpoints, or other devices are still
sensing a fire or smoke, or a fault, then the panel go back into an alarm condition.
Silence Alarms Button
When an alarm occurs, certain sounders throughout the building will activate. Which
sounders and how many depends upon the configuration of your system. Pressing the
"Silence Alarms" button silences (switches-off) these sounders. When this is done, the
"Sounders Silenced" indicator above the button will illuminate.
Sound Alarms Button
Pressing the "Sound Alarms" button will activate all the sounders in the building. It can be
used as a general alert, or to restore sounders that have been inadvertently silenced.
Restore Disabled Alarms Button
Certain alarm sounders, and the remote manned centre alarm, can be disabled by
maintenance staff, for routine maintenance. If a fire alarm were to occur while these devices
were disabled, the sounders and fire brigade connection would not operate. Pressing the
"Restore Disabled Alarms" button restores disabled sounders and RMC alarms. It also
cancels any programmed delays, over-riding them and creating an immediate alarm. The
button does not create an alarm; it merely restores alarm devices to enable them to operate
correctly during an alarm.
RESTORE
DISABLED
ALARMS
LOCAL ZONES
1
9
17
25
33
41
49
2
10
18
26
34
42
50
3
11
19
27
35
43
4
12
20
28
36
44
5
13
21
29
37
45
6
14
22
30
38
46
7
15
23
31
39
47
8
16
24
32
40
48
ZP3 FIRE ALARM SYSTEM
HELP
MORE
VIEW
POINTS
DISABLED DELAYED PRE-ALM TEST ENABLE
CONTROL
ON
OFF
FAULT ACTIVE POWER ON
SYSTEM NIGHT
ZONE DAY
POINT MORE TIME
SOUNDERS
REMOTE ALARM
FIRE FAULT DISABLED RESET
SILENCE
ALARMS
SOUND
ALARMS
CONTROL OUTPUTS
ACCEPT
MUTE
BUZZER
OTHER
Reset Button
Accept Button
Silence Alarm Button
Sound Alarm Button
Restore Disabled
Alarm Button