Ziton ZP3, Установка, эксплуатация и обслуживание

Страница: 50 / 239

ZP3 Fire Control Panel
ZP3 Panel
ZP3 Fire Control Panel Manual
Page 2 - 20 UD1160.2 Iss 6 (25/02/2005)
I
2
7. Switch on the panel.
8. Initialize the modem by accepting devices.
9. View the accepted devices using the reports to display function ensuring that the
modem device is reported with its correct software and version. The modem interface
card’s 'power on' and 'modem on' LEDs should be illuminated.
10. Use the comms parameters setup option to define the modem baud rate and protocol.
Set the Z-port 1 port settings as follows.
Protocol: ZCP3
Baud rate: 38400
Note: If a Planner PC is plugged directly (via Z-port 1) into a panel that is fitted with a
modem, then the modem must be disconnected from Z-Port 1a by removing the
RS232 connection plug (1) to the ZAB-RS232 board (2). If the modem is not
disconnected the panel will report an Earth fault.