Ziton ZP3, Установка, эксплуатация и обслуживание

Страница: 132 / 239

ZP3 Fire Control Panel
System Configuration
ZP3 Fire Control Panel Manual
Page 7 - 2 UD1160.7 Iss 6 (25/02/2005)
I
7
Local Programming
The panel may be configured so that it can be programmed from the fascia keypad, or not. If
set to no local programming, then it can only be programmed via a PC, and downloaded into
the panel. This can provide a higher level of security to prevent unauthorized on-site
changes to the configuration.
Networking
Panels must be defined as standalone or part of a network.
Zone Allocation
All input devices on a loop must be assigned to a zone. This includes sensors, callpoints,
and interface units. Output devices such as sounders and line relays can be optionally
zoned if required. Zones must be specified and numbered, and the point addresses
belonging to each zone must be defined.
Zone Identification Messages
Each zone requires an identification message. This message can be up to 29 characters in
length. If the feature which displays the time of each alarm on-screen is enabled, then the
available space for the zone message is reduced to 23 characters. It is not necessary to
include the zone number in the message, as this is displayed automatically.
Point Information
The address of each point to be used in the system must be defined, together with the type
of device at each point address.
Device Identification Message
Each device in the system has an identification message, which is tagged to the point
address of the device. For Z-loop devices this message can be up to 40 characters in
length. For panel outputs, the message can be 10 characters in length.
Detector Self-test
ZP700 series sensors have a self-test capability that is used by the panel to automatically
test them every 24 hours. This test is optional, and can be specified on a device-by-device
basis. Certain devices on the loop (for example, conventional detectors connected via
interface units), do not have a self-test facility, and would have this function disabled. The
default setting is [SELF-TEST OFF].