Ziton ZP3, Установка, эксплуатация и обслуживание

Страница: 175 / 239

ZP3 Fire Control Panel
Operators Instructions
ZP3 Fire Control Panel Manual
UD1160.O Iss 6 (25/02/2005)
Page 1 - 15
I
O
1.5 Operator Response
1.5.1 Fire Alarms
A fire alarm will display on the panel as described below. The actions carried out upon
receipt of a fire alarm will depend upon the fire alarm procedures at the organization where
the alarm occurred. The following are generic guidelines only.
Annunciation and Alarm
Common "Fire" LED's: Illuminated.
Zone LED: Illuminated, indicating which zone is in alarm.
Text display: Zone screen showing details of zone in alarm.
Panel Buzzer: Sounding intermittently.
Building Sounders: Those configured to operate will be sounding.
Auxiliary Functions: Those functions configured to operate will be active, such
as calling the remote manned centre, shutting air-
conditioning, etc.
Status Indicators: Will be illuminated if these functions were configured to
operate. The LED's will indicate which functions have
been activated, such as remote manned centre,
sounders, etc.
Delayed Functions: Certain functions might be configured as a delayed
operation. These could be sounders, remote centre
alarms, or control functions. If a function has been
triggered to operate after a delay, then the "delayed" LED
on the status indicator will illuminate.
Operator Action
Accept the alarm by pressing the "Accept" button. This will silence the panel buzzer, and
cause the flashing alarm indicators to go steady. The panel buzzer will "chirp" intermittently
every 30 seconds to remind you of the alarm. Do not press "reset" or the "silence alarms".
Identify the zone from which the alarm originated. Check the area (zone) to ascertain the
extent of the problem. For example, telephone the zone fire marshal, or send someone to
the area.
During this time the sounders in the area will be sounding. Only when you are sure that the
situation is under control, or that the people from the area have been evacuated, press the
"silence alarms" button to silence the building sounders. If the sounders were switched-off
inadvertently, press the "sound alarms" button to switch the sounders on.
After the alarm, restore the device which initiated it (for example, remove smoke, or replace
the glass in a callpoint), and then press the "reset" button. The system will restore to normal.