Ziton ZP3, Установка, эксплуатация и обслуживание

Страница: 145 / 239

ZP3 Fire Control Panel
System Commissioning
ZP3 Fire Control Panel Manual
UD1160.8 Iss 6 (25/02/2005)
Page 8 - 1
I
8
8.1 Introduction
After the ZP3 fire control panel, and the other system elements, have been installed, it is
necessary to commission the system. The purpose of the commissioning is to ensure that
the system operates correctly, and the following areas must be checked:
i The system has been correctly designed
ii All equipment has been properly installed
iii The software functions have been correctly programmed
iv Sensors are appropriate for their environment
v All sensors function correctly
vi All outputs operate correctly
vii Cause and effect linkages are correct
viii The complete system is functioning correctly
ix. The system will continue to function reliably.
8.2 Verification
The following elements must be verified as being correct. Some of these items can be
checked using the printout from the Ziton Planner programming software, others require on-
site checking, testing and measurement. The commissioning process must cover the
following items.
Verify system design
Verify that the system design satisfies the requirements of the system specification (usually
produced by the project consulting engineer, or similar person). Check that that the correct
types of sensors are fitted into each area, and that equipment complies with the
specification.
Where a system is required to comply with the design criteria of a National Standard (such
as BS5839 part 1; Design of Fire Detection Systems), then verify that the installation does
comply with these requirements.
Verify equipment Installation
Check and verify that all the items of equipment (sensors, callpoints, fire panels, etc) have
been installed in accordance with the manufacturers instructions and recommendations.