Ziton ZP3, Установка, эксплуатация и обслуживание

Страница: 188 / 239

ZP3 Fire Control Panel
Operators Instructions
ZP3 Fire Control Panel Manual
Page 1 - 28 UD1160.O Iss 6 (25/02/2005)
I
O
1.7.2 Routine Checks
The following are the details of the daily and weekly checks that must be carried out to
ensure that the system is operational at all times.
Important
Occupants of the building and anyone receiving remote alarm signals, such as the fire
department, should be informed prior to the test. They must also be informed when the test
is complete. No alarms should be activated before notification has taken place.
Any external systems that are connected to the fire system, such as fire extinguishing
systems, air-conditioning systems, or lifts, should be temporarily disabled while testing is in
progress. It is essential that all disconnected or disabled systems be reconnected at the end
of testing.
Daily checks
• Check that only the Green Power-on indicator is illuminated. All other LED's should be
off and the panel should be silent. The display should show the time and date only.
•
If the panel is indicating a fault alarm, contact the maintenance staff and arrange for
the fault to be rectified.
•
Maintain the logbook up-to-date. Check that all faults recorded in the log book the
previous day has been attended to.
• Check that the correct time and date are displayed. If not, then correct the time/date.
Weekly Checks
•
Check that all LED's are operational by carrying out a lamp-test.
•
Operate at least one device (fire sensor or callpoint) in a zone. The zones should be
rotated to ensure that they will all be tested over time.
•
Check that the required sounders operate.
•
If the system is connected to a remote manned centre, check the alarm was received.
•
If the fire system controls the operation of auxiliary equipment, check that this did
occur.
•
Accept the alarm, and press the "Silence Alarms" button. Check that the sounders
silence.
• Reset the system.
•
If the panel has a printer, check that it recorded the events correctly. Check that it has
sufficient paper, and that the print ribbon is not dry. Verify that the paper feeds
correctly.
• Make sure that the panel exterior is clean by lightly polishing with a dry cloth.
Important: If any defects are discovered during the routine testing, they should be
recorded in the log book and action taken to have them corrected.