Ziton ZP3, Установка, эксплуатация и обслуживание

Страница: 170 / 239

ZP3 Fire Control Panel
Operators Instructions
ZP3 Fire Control Panel Manual
Page 1 - 10 UD1160.O Iss 6 (25/02/2005)
I
O
1.3.7 Status Indicators
A status indicating section of the fascia gives a comprehensive overview of the current status
of the complete fire detection system, as described below.
On this indicator the system is categorized, on the left side, into different elements, as
follows:
System The panel and the complete system, including the CPU.
Zone A grouping of sensors, or other line devices.
Point A single line device, such as a sensor, callpoint, or sounder, etc.
Sounders Alarm devices, including electronic sirens, bells, etc.
Remote Alarm Alarm to a Remote Manned Centre (RMC), such as a Fire Brigade.
Control Outputs Output devices internally mapped as "Control Outputs" used to control
building systems such as air conditioning detection etc.
The status indicators have been categorized by column as shown in the illustration above,
and the following conditions are indicated.
Power On Indicates that the ZP3 panel has power, either from the mains or from
the standby battery.
Active Indicates that a sounder, remote alarm, or extinguishing system has
been activated.
Fault Indicates that a fault condition has been detected on a device or
output. A "System-Fault" indicates that a major fault exists in the
panel.
Disabled Indicates that a device or output has been deliberately disabled.
Delayed Indicates that the activation of a sounder, remote alarm, or control
output has occurred, but that the actual operation of the output is in a
delayed state.
Pre-Alarm Indicates that a zone or sensor is in a pre-alarm condition, or if the
system has been setup for coincidence detection.
Test Indicates that the panel is in a test mode, which can be initiated either
manually or automatically.
*(two active detectors to raise an alarm) then this led indicates if one
detector only is active.
DISABLED DELAYED PRE-ALM TEST ENABLE FAULT ACTIVE POWER ON
SYSTEM
ZONE
POINT
SOUNDERS
REMOTE ALARM
RESTORE
DISABLED
ALARMS
LOCAL ZONES
1
9
17
25
33
41
49
2
10
18
26
34
42
50
3
11
19
27
35
43
4
12
20
28
36
44
5
13
21
29
37
45
6
14
22
30
38
46
7
15
23
31
39
47
8
16
24
32
40
48
ZP3 FIRE ALARM SYSTEM
HELP
MORE
VIEW
POINTS
CONTROL
ON
OFF
NIGHT
DAY
MORE TIME
RESET FIRE FAULT DISABLED
SILENCE
ALARMS
SOUND
ALARMS
CONTROL OUTPUTS
ACCEPT
MUTE
BUZZER
OTHER
Status Indicators