ZIEHL-ABEGG ZETADYN 3C, Оригинальная инструкция по эксплуатации

Страница: 145 / 204

Error no. Error text Error cause M S
590 RV1/RV2:Change
Fault:
Change the direction speci
fi
cation during active travel
Additional information:
Display of the set direction
1 = RV1
3 = RV2
Remedy:
Check control of travel directions
● ●
13.5.9 Error 7xx
• Trip abort due to errors between frequency inverter and control system
Error no. Error text Error cause M S
710 DCP: Timeout Error: DCP communication interrupted during travel
Remedy:
check wiring (shields)
● ●
715 DCP: G0-G7 fail !
Error:
Transmission error in the DCP protocol: Telegram for the speed preset
(G0-G7) not received
Remedy:
Possibly the DCP-function of the elevator control is not compatible
● ●
720 DCP: Delay fail
Error:
The DCP residual path increases during deceleration by more than 5cm
Remedy:
Check the absolute rotary encoder for its residual path determination
Wrong residual path signal from open loop control
● ●
721 DCP: Dist. fail
Fault:
There is no change in the residual path for 200 ms during the run
Remedy:
Check the absolute rotary encoder for its residual path determination
Wrong residual path signal from open loop control
● ●
722 DCP: s_rest = 0?
Error:
Residual path > 20mm jumps to 0mm
Remedy:
Check the absolute rotary encoder for its residual path determination
Wrong residual path signal from open loop control
● ●
723 DCP: s_rest < 0!
Error:
A negative residual path is transmitted during travel
Remedy: Check the DCP wiring
● ●
780 DCP: Quick Start >20s
Error:
In the quick start function, input "V=0" is triggered for over 20s
Remedy:
Shorten the time in which "V=0" is triggered
● ●
781 v0 at travel ?!l
Error:
Input "V=0" is triggered during travel
Remedy:
Check the triggering of "V=0"
● ●
799 RF:Failure
Error:
Control enable RF was switched off during travel (error evaluation only if
error no. 799 is entered in the error mask)
Remedy:
Check the triggering of "RF"
● ●
13.5.10 Error 8xx
• Errors which can occur in operation with CANopen Lift
If an error occurs during operation with CANopen, the frequency inverter runs through status "ST_De-
lay" and
fi
nally goes to status "Wait drivecom. off". At this status the frequency inverter waits until the
control system sends the command "Fault Reset".
Error no. Error text Error cause M S
800 CAN: Timeout
Errors in Velocity Mode:
Heartbeat from control system is missing or at wrong time.
Errors in Position Mode:
Heartbeat from control system and/or encoder is missing or at wrong time.
Adjustment:
Check CAN-connection
Check if devices have the right heartbeat.
●
810 CAN: Quick Stop Det.
Error:
Control system activates a quick stop.
820 CAN: Illegal Status
Error:
Control system sends commands in wrong order.
Adjustment:
Take care to the right order in CAN drive cycle
●
Original operating instructions
ZETADYN 3C
Error diagnosis
R-TBA08_03-GB 1619 Part.-No. 00163322-GB
145/204