ZIEHL-ABEGG ZETADYN 3C, Оригинальная инструкция по эксплуатации

Страница: 95 / 204

Parameter Description Value range
Factory set-
ting
CHN1
Con
fi
guration of the measuring channels 1-4 with analog meas-
urement values
1:
setted speed [m/s]
3:
acutal speed [m/s]
6:
Internal status (inverter status)
16: fl
ux build-up current [A]r
26:
motor current [A]
27:
motor voltage [V]
31:
temperatur power section [
°
C]
49:
covered total travel distance [m]
62:
residual path by the control system [mm] (only wirh DCP2 or
DCP4)
119:
Capacity of the Brake-Chopper / Brake resistor
142:
Intermediate circuit voltage [V]
143:
torque build-up current [A]
0...299
3
CHN2
1
CHN3
143
CHN4
6
CHN5
Con
fi
guration of the measuring channel 5 with digital measure-
ment values
89:
digital in- and outputs with indication of the function
90:
digital in- and outputs optimized for brake monitoring
91:
digital in- and outputs
92:
DCP-order and statusbits
0...299 89
10.18 Encoder adjustment menu
Contains parameter values required for aligning the SSI/EnDat rotary encoders for synchronous
motors.
The procedure for entering the encoder alignment data is described in the "Special functions" chapter.
Parameter Description Value range
Factory set-
ting
ENC_ADJ
Activating the encoder alignment
Off:
no function
ON:
Starts the encoder offset or control of the encoder offset
alignment
On
Off
Off
ENC_POS
Encoder Position
Numerical display of the absolute position of the encoder per
revolution:
0
…
[4x number of grooves in encoder]-1
Cannot be set -
ENC_OFF
Encoder Offset
Shifts the zero position of the absolute rotary encoder to the
pole's electrical zero position
EnDat encoder:
Default 0 is absolutely necessary
SSI encoder:
if the SSI encoder is not mechanically mounted in
the zero position, the value ascertained during the offset align-
ment (ENC_ADJ) for ENC_OFF must be entered
0 ... 360.00
°
0
Original operating instructions
ZETADYN 3C
Parameter list
R-TBA08_03-GB 1619 Part.-No. 00163322-GB
95/204