ZIEHL-ABEGG ZETADYN 3C, Оригинальная инструкция по эксплуатации

Страница: 111 / 204

11.5 Traveling speed defaults
After entering the installation speci
fi
cations and carrying out the automatic parameter assignment, the
traveling speeds "V_2" and "V_3" are pre-con
fi
gured in the
Travelling
menu, dependent on "V*".
Description Parameter pre-signment
Intermediate speed V_2 V_2 50% V*
Travel speed V_3 V_3 100% V*
The speeds listed in the table below are permanently preset and thus independent of "V*".
Description Parameter pre-signment
Positioning speed V_1 0,05 m/s
Readjustment speed V_Z 0,05 m/s
Additional speed V_4 V_4 0,32 m/s
Additional speed V_5 V_5 0,32 m/s
Additional speed V_6 V_6 0,32 m/s
Additional speed V_7 V_7 0,32 m/s
11.6 Distance-dependent deceleration
In a path-dependent deceleration, the deceleration paths are always identical. Independent of the
speed reached at the start of the deceleration.
The path-dependent deceleration can be activated in the menu
Decelerating/S_ABH = ON
Path dependent deceleration is carried out during deceleration of:
•
V3
R
V1
• V2
R
V1
• V3
R
Drehzahl 0 (only in DCP2/DCP4 protocol)
• V3
R
Drehzahl 0 (only in DCP2/DCP4 protocol)
During all other switchovers between two speeds, the deceleration is carried out time-dependent.
Information
Before removing the digital input for the travel speeds V_3 or V_2 the input for the travel speed V_1
must be applied (see diagram "Normal stop at distance-dependent deceleration").
If it is not possible to control two travelling speeds simultaneously for technical reasons (e.g. control of
the speeds by an alternating contact), the distance-dependent delay with the
Control system/SIM_-
V1=ON
parameter can be activated!
Here it must be noted that the positioning speed V_1 must be activated 100 ms after deactivation of
the travelling speeds V_3 or V_2 at the latest!
If binary speed is speci
fi
ed, there is only a distance-dependent delay at
Control system/SIM_V1=ON
!
Information
If the signal for the higher traveling speed (e.g. V_3) is switched off for a short time, the inverter
decelerates the motor to positioning speed V_1. For safety reasons, retriggering a higher traveling
speed is ignored. Triggering at a higher traveling speeds is only possible after all the inputs for the
traveling speed have been switched off and the motor has reached the speed 0.
Original operating instructions
ZETADYN 3C
Travel options
R-TBA08_03-GB 1619 Part.-No. 00163322-GB
111/204